History lesson | Parachute Knowledge | Parachute Knowledge Pt. 2 | Flight Clothing | Random |
---|---|---|---|---|
Albert Berry
Who was the first person credited for successfully jumping from an aircraft using a parachute?
|
Bias
The sections used in a parachute canopy are cut at a 45-degree angle to the centerline of the gore. This is know as what type of construction?
|
20 pounds
When inspecting suspension lines during an original issue inspection, how much tension is applied to the line?
|
Height, weight, and chest measurements
What are the size criteria should be used to fit anti-exposure assemblies to aircrew members?
|
35
The TRISAR harness assembly provides a minimum of __________ pounds of
buoyancy. |
1924
When did it become mandatory for all Army and Navy aircrew to wear the standard back-type parachute while in flight?
|
Maintenance Control Officer
Periodic maintenance for parachute falls under the direction and control of the ____________.
|
Increasing air pressure as the aircrewman falls
When an aircrewman makes an emergency ejection at an altitude
|
4 through 12
What are the available sizes for the GS/FRP-2 flyer's gloves?
|
SDU-39/N
Which of the following distress signals is commonly called a strobe light?
|
1942
In what year was the PR rate established?
|
7 years
If a canopy used in an emergency fails to show a start-of-service data, what will be the service life of the canopy from the date of manufacture?
|
4 to 6
How many stitches per inch are used to sew a parachute harness?
|
700° to 800°F
The CWU-27/P and CWU-73/P summer flying coveralls are made from an aramid cloth. This material will not support combustion, but will begin to char a what temperature?
|
1 hour
The dye marker ceases to be a good target after __________.
|
USS United States
What was the name of the first of the 6 original frigates in the NAVY?
|
Section A of gore 28
Where can the date of manufacture be found on a 28-foot canopy?
|
Canopy Damage Chart
Whenever a canopy is inspected and needs repairs, what form is initiated?
|
Continuous wear
Quick-donning Protection
What are the three main goals for the design and characteristics of the anti-exposure assemblies?
|
The aircrew member
Before and after each mission, who is responsible for performing the preflight and postflight inspections on the helmet assembly?
|
45 years
How long was the Cold War?
|
300 pounds
Ripcord pins are swaged in place and tested at __________.
|
Repair it using 6-cord
If a harness assembly has two broken stitches, what action, if any, should be taken?
|
NAVAIR 13-1-6.7-2
Which technical manual provides the fitting guidelines for flight clothing?
|
20 seconds
Each end of the Mk 124 Mod 0 signal flare will burn for approximately __________
|