An angle that is 180° exactly

Within CAD, you can draw a CIRCLE by entering its:

When drawing an isometric pictorial, which CAD command is used to draw a circle?

What shows the front view as if a person was looking directly at it?

Multiview drawing are called what?

An angle that measures less than 90 degrees iscalled a/an:

When drawing an isometric pictoral, which CAD command is used to draw a circle?

Which CAD command will allow you do draw a HEXAGON?

what are the two types of oblique sketches?

which best describes a figure with four sides of equal length and four 90 degree angles?

An angle that measures 90 degrees is called a/an:

In a CAD system, when you specify X and Y points, you are drawing in:

Which CAD command allows you to draw a series of lines and arcs as a single entity and specify width?

What oblique sketch is often used?

What are the materials required for making a sketch?

An angle that measures more than 90 degrees is called a/an:

What type of coordinates in a CAD system are entered with respect to the last point entered?

You are using a CAD system to dray a polygon. After drawing a series of straight lines, you enter the letter "C" from the keyboard. You intend to:

showes the object is shown viewedfrom one corner?

which best describes a four-sided figure with opposite sides of equal length and four 90 degree angles?

How are angles of 30 degrees and 60 degrees sketched?

A keyboard entry of, @ 5.625<45, refers to:

When using CAD to draw a 45 degree line
that is 3 units long, you should input:

A drawing that is shown as if one personis looking at it?

Which best describes an eight-sided polygon?