| PSCG and It's Functions | Welcome to the ECS | How Much Do You Know? | Control and Display | Mode Control Specifics |
|---|---|---|---|---|
|
What is +27 VDC
This Voltage is used by the WCG Computer.
|
What is 60F or below.
This is the temperature in which the Radome Heater is activated.
|
What is 5 - 1,2,3,13&14
The Number of UNITS included in a 1B B/L 0 Mount Configuration.
|
What is AIR READY
The lowest mode in which you may command SURFACE Mode from.
|
What is BATTERY OFF
The Lowest Operating Mode of CIWS.
|
|
What is 29 (1A) or 32 (1B)
This is the number of Circuit Breakers on the 2A6A1 Front Panel Assembly.
|
What are Flow Switches/Flow Sensors
There are Four (4) of THESE in the Coolant Loop.
|
What are System Control Keyswitch to OPERATE and MOUNT WARNING.
You need to do these two (2) things prior to pressing AIR READY, according to the proceedure.
|
What is Passive Ranging
The default Ranging method in Surface mode.
|
What is 3
The number of phases that make up Air Ready.
|
|
What are 115v (VRU) and 26v (RSI)
These two voltages are converted into 400 Hz in the PSCG.
|
What is 3 (+/-2) psi
The Waveguide is pressurized to this psi.
|
What is the 2A12(A1) Front Panel
This Drawer/Door houses Two TIM CCAs and Two Voltage Conditioner CCAs.
|
What are +12vdc and +5vdc
THESE Voltages are used exclusively for the VME Bus and CCAs.
|
What is STANDBY
Lowest Mode of Operation that you can "Hand over" control to the RCP.
|
|
What is 10 seconds (Approx.)
The length of time needed for the Power Quality Monitor (PQM) to complete One full Override Cycle.
|
What is 30 seconds
The normal cycle time for the WADS Tower to change between the Upper and Lower Dryer Assemblies.
|
What is PRE ARM/ARM/SAFE button (Switch)
If all conditions are met, pressing THIS button will give you a GUN STATUS GO indication.
|
What is the PSP CCA
The "WCG for the EO Subsystem".
|
What is STANDBY (Just)
The System wil default into THIS Mode if the Mount Safety switch is Set to SAFE.
|
|
What are +/- 28.5 vdc and +/- 8.5vdc
These Voltages are monitored by 2A12A1A2 producing the ELX OK - H signal, turning the ELX POWER Switch to green.
|
What is the ELX Temperature (sensor)
This ECS Sensor (2A14S7) is misleading because it is located behind the 2A9 drawer.
|
What is CSOSS
Tables 3-19 and 3-20 are used to make up THIS proceedural Document.
|
What is TARGET DATA - HEIGHT Readout
The Standby countdown is displayed in THIS Readout on the LCP.
|
What are STANDBY and STANDBY-ELX (AIR READY)
The EM and ELX Power Supplies are activated in THESE Modes, Respectively.
|
Support Us on Ko-fi