| Gears, Chains, & Bearings | Mechanical Components | Control Components | Transaxle/Final Drive | Service and Rebuild |
|---|---|---|---|---|
|
Reduction
What type of gear ratio obtains the best acceleration from a stop?
|
clutches, bands
The most common holding members are _______ and _______.
|
True
True or False?
Some transaxle oil pumps are driven by a separate shaft instead of the rear of the torque converter. |
True
True or False?
The shape of the oil pan can be used to help identify the type of transmission or transaxle being serviced. |
feeler gauges
_______ _______ are the proper tool used for checking clutch pack clearance.
|
|
Overdrive
What type of gear ratio should be selected to obtain the best fuel economy?
|
turbine, impeller
The stator redirects fluid moving from the _______ to the _______.
|
Everywhere
According to Pascal's Law, the pressure in a closed hydraulic system is the same in what area(s) of the system?
|
True
True or False?
Some transaxles have more than one oil pump. |
False
True or false?
Dexron fluid can be used in all transaxles as long as they are not overfilled. |
|
False
True or False?
The use of an idler gear affects gear ratio. |
False
True or False?
The clutch pressure plate is installed next to the apply piston. |
D) Vanes
Which of the following components is NOT used on all hydraulic pumps?
A) Inlet port B) Power source C) Outlet port D) Vanes |
True
True or False?
Many final drives can be serviced with the transaxle in the vehicle. |
True
CVT service requires special disassembly tools.
|
|
Torrington
A _______ bearing is often used as a thrust washer.
|
planetary gearsets
Automatic transmission holding members function by holding or driving parts of the _______ _______.
|
B) Control oil flow
Spacer plate holes are drilled to certain precisely controlled sizes to:
A) prevent oil leakage B) control oil flow C) cool the oil D) Both A and B |
preloaded
Before any adjustments are made to a hypoid ring and pinion gearset, the bearings must be _______.
|
check ball
A valve body spacer plate should be replaced if the _______ _____ orifices are pounded out.
|
|
interference
A press fit is an example of an _______ fit.
|
D) Both A and B
Torque converter stall speed is affected by:
A) the curvature of the impeller, turbine, and stator blades. B) the torque output of a particular engine. C) running out of gas. D) Both A and B |
Both A and B
Technician A says that changing the sizes of the input and output pistons can change the distance traveled. Technician B says that changing the sizes of the input and output pistons can change the amount of force from the output piston. Who is right?
|
diverters
In transaxles, oil scoops are used to keep some non-pressurized parts from being oil starved, while oil _______ are used to keep some parts from being over lubricated.
|
clutch packs and servos
What two components can be (should be) checked with air pressure before the valve body is installed?
|
|
Simpson
The _______ gear train is a compound planetary gear set consisting of two separate ring gears, two separate planetary sets, and one common sun gear that is splined to the sun gear shell.
|