A type of bearing that contains needle rollers that are arranged radially

The part of the engine that produces the vacuum used to operate vacuum devices.

A _______ transaxle varies the drive ratio by varying pulley diameter.

The hydraulic device used in the apply circuit of a band or clutch to cushion initial application is the _______.

When rebuilding an automatic transmission, you should work on one _______ at a time, so that parts are not mixed up.

This component is used to operate a band.

Hydraulic pumps produce hydraulic _______.

_______ drives are used on transaxles installed on longitudinal engines.

The _______ valve is used to modify pressure according to vehicle speed.

Leopard spotting is a sign of excessive _______.

The part of the torque converter that turns whenever the engine is running.

Hydraulic leverage is gained by varying the _______ of the input and output pistons in a hydraulic system.

The shaft between the converter and drive sprocket is called the _______ shaft.

Some automatic transmissions use a _______ valve to aid downshifting.

Check the torque converter endplay with a _______ _______.

Fluid leaving the turbine of the torque converter must pass through this component before reaching the impeller.

Hydraulic _______ are used in a hydraulic circuit to control pressure, along with the direction and rate of fluid flow.

The transfer shaft drives the _______ gear.

A 3-speed automatic transmission would have how many shift valves?

Pump wear can sometimes be determined by the use of _______ _________.

Two or more planetary gearsets can be linked together to form a _______ planetary gearset.

_______ law states that pressurized liquid transmits equal pressure to all points within a container.

The _______ element keeps the bottom oil pan from being overfilled when the tranaxle fluid is hot.

The vehicle speed at which an upshift occurs is limited by _______ pressure.

If there is too _______ clutch clearance, the clutch pack may not apply tightly and may slip.