Career Success






Tools Measurement & Math Miscellaneous (it's a surprise!) Fasteners & Seals Vehicle Maintenance
$10
What is forward
When using a hacksaw, you should only apply pressure on the __________ stroke.
$10
What is the Metric System
This measurement system is the most widely used, especially outside the United States
$10
What is False
True or False: a magnetic pickup tool will attract any kind of metal
$10
What is a nut
A fastener that has internal threads
$10
What is a filter wrench
This tool should NOT be used to tighten "snug up" the engine oil filter after an oil change: _________
$20
What is mushroomed
You can grind and form a chamfer on the head of a chisel or punch if it becomes _____________
$20
What is False
True or False: A metric micrometer is graduated to provide readings in tenths of inches
$20
What is ONE
Proper filing speed is about ______ stroke per second
$20
What is a cotter pin
A device used with a slotted nut to prevent it from turning
$20
What is a dipstick
This is often built into the cap of a power steering pump
$30
What is 1/2"
The most common socket wrench drive sizes are 1/4", 3/8", and ___________
$30
What is decimals
The most accurate unit for measure for anything smaller than 1/64 inch
$30
What is 2 3/8"
What is the measurement at point "B"?

View Image
$30
What is False
True or False: sealer must always be used when installing a gasket
$30
What is chassis grease
A good all-around body lubricant is _________ _________.
$40
What is an inside micrometer
The tool that should be used to precisely measure a cylinder bore
$40
What is 7.74 mm
What is the micrometer reading shown?

View Image
$40
What is system
An automotive ___________ is a group of related parts that perform a specific job
$40
What is coarse
Type of thread used for better holding power when tapping into soft metals like aluminum
$40
What is 1" (1 inch)
On some older vehicles, the coolant level should be how far below the top of the filler neck of the radiator?
$50
What is oxygen
A cutting torch generates tremendous heat by burning acetylene and what other gas?
$50
What is .241"
What is the micrometer reading shown?

View Image
$50
What is splines
A series of slots cut into a shaft and a mating part that allow the part to slide on the shaft but still not rotate
$50
What is a lock washer
A device used to prevent the loosening of a fastener because of vibration
$50
What is above and in front of
The likeliest direction to look for leak if you find fluid dripping from a vehicle is _________ and in __________ of the drip point.
What is dependability
The number one reason that technicians are fired is a lack of _________________

AUTO 103 Mid Term Review

Press F11 for full screen mode





Clone | Edit | Download / Play Offline