105 Jeopardy Template

Cutting	Test Your Luck	Texturizing	Shears& Razor	Misc.
100 The most natural looking result of the design line is achieved when cutting the hair in which of the following head positions? upright	100 What is the result of using higher projection when cutting the hair? less weight buildup	100 Coarse hair should be texturized at east how far away from the scalp? 1 1/2" (3.75 cm)	100 Which finger should be placed in the finger grip to control the still blade when holding shears? ring	100 What is the top or the highest point of the head Apex
200 Projection, also known as elevation, is the angle at which the hair is held in relation to the? curve of the head	200 Which line is considered to be the artistic pattern or length guide used while cutting hair? design line	200 For control and to observe the shrinkage factor, curly hair should be texturized while it is? dry	200 The movable blade of the shears is controlled by the? thumb grip	200 What is the area all around the hairline Perimeter
300 Projection the hair below 90 degrees would? build bulk	300 A constant, stable guide to which all lengths are directed is referred to as a? stationary design line	300 Texturizing reduces bulk without? shortening the overall appearance of length	300 Taper shears, also known as thinning shears, are used on the ends of hair to create? mobility	300 What is the area in the upper back and on top of the crest area, begins where the top of the head begins to curve downward Crown
400 An angle of 45 degrees would be considered what type of projection? medium	400 Which of the following terms identifies the technique used to check the balance and accuracy of a haircut by using the line opposite the original parting pattern? cross-checking	400 Which area of the head should you avoid thinning the hair? hairline	400 For the comfort of the client, it is essential that the hair be damp throughout, when cutting with which of the following tools? razor	400 What is divided by a line that runs from the apex to each ear Front & Back
500 Which of the following angles best represents low projection? 0 degrees to 30 degrees	500 To accommodate a growth pattern such as a widow's peak, cowlick, or whorl when cutting the hair, which of the following statements would apply? allow additional length in the growth pattern area	500 Slightly closed shears moved down the strand to produce a rapid length increase in which of the following techniques? slide cutting	500 To hold the comb and shears in the same hand without jeopardizing the client's safety, release the thumb grip and: close your palm over the shears	500 What is the 7 sculpting procedures 1. section 2. head position 3. part 4. distribution 5. project 6. finger/shear position 7. design line

105

Press F11 for full screen mode